# wally-coremark.do # # Modification by Oklahoma State University & Harvey Mudd College # Use with Testbench # James Stine, 2008; David Harris 2021 # Go Cowboys!!!!!! # # Takes 1:10 to run RV64IC tests using gui # Use this wally-coremark.do file to run this example. # Either bring up ModelSim and type the following at the "ModelSim>" prompt: # do wally-coremark.do # or, to run from a shell, type the following at the shell prompt: # vsim -do wally-coremark.do -c # (omit the "-c" to see the GUI while running from the shell) onbreak {resume} # create library if [file exists work] { vdel -all } vlib work # compile source files # suppress spurious warnngs about # "Extra checking for conflicts with always_comb done at vopt time" # because vsim will run vopt # default to config/coremark, but allow this to be overridden at the command line. For example: #vlog +incdir+../config/coremark_bare +incdir+../config/shared ../testbench/testbench-coremark_bare.sv ../testbench/common/*.sv ../src/*/*.sv ../src/*/*/*.sv -suppress 2583 vlog +incdir+../config/rv64gc +incdir+../config/shared ../testbench/testbench-coremark_bare.sv ../testbench/common/*.sv ../src/*/*.sv ../src/*/*/*.sv -suppress 2583 # start and run simulation # remove +acc flag for faster sim during regressions if there is no need to access internal signals vopt +acc work.testbench -o workopt vsim workopt mem load -startaddress 268435456 -endaddress 268566527 -filltype value -fillradix hex -filldata 0 /testbench/dut/uncore/ram/ram/RAM #add log -recursive /* do wave.do run -all #run 21400 #quit